FX series PLC basic logical instruction 20 or 27, step instructions 2, command more than 100 pieces (different series). FX2N this section, for example, described its basic logic instructions and step ladder instruction and its application.FX2N total 27 basic logical instructions, containing some 20 basic logic series PLC instructions.Master instruction (MC/MCR)(1) MC (master instruction) for … Continue reading Mitsubishi FX series PLC master command (MC / MCR)

FX series PLC basic logical instruction 20 or 27, step instructions 2, command more than 100 pieces (different series). FX2N this section, for example, described its basic logic instructions and step ladder instruction and its application.FX2N total 27 basic logical instructions, containing some 20 basic logic series PLC instructions.Stack directive (MPS/MRD/MPP)Stack instructions are the new … Continue reading Mitsubishi PLC MPS, MRD, MPP instructions

0 LDP X000 1 ORP X001 2 OUT M0 3 LD M8000 4 ANDP X002 5 OUT M10 LDF X000 1 ORF X001 2 OUT M0 3 LD M8000 4 ANDF X002 5 OUT M1

Instructions:When the branch circuit (parallel circuit) circuit when connected in series with the front, use the ANB instruction, starting point for branch with LD,LDI command, ANB for parallel circuit blocks after the end of the instruction, and in front of the circuit in series.  0 LD X000 1 OR X001 2 LD X002 3 AND X003 … Continue reading Mitsubishi PLC ANB instruction

Instruction descriptionMore than 2 contacts connected in series circuit series circuit. Series circuits connected in parallel connection, the branch started with LD, LDI instruction and branch ends with ORB instruction. ORB told ANB behind the directive and directive, is without a soft element address number of independent instructions. When there are multiple parallel circuits, if using ORB … Continue reading Mitsubishi PLC PLC’s ORB instruction

Instructions:OR parallel connection, ORI/1 contact instructions.More than 2 contacts connected in series and this series circuit with other circuits connected in parallel, using ORB directives referred to later.OR,ORI is the directive from the start, and the previous step LD,LDI instructions, connected in parallel. No restrictions on the number of parallel connections, but when using the … Continue reading Mitsubishi PLC PLC’s OR, ORI instructions

When M1536-M3071 is used, procedure step 1. Instructions: 1 point of contact with the AND,ANI instruction can be connected in series. Unlimited contacts in series, this directive can be used multiple times. OUT instruction, through contacts on the other coil uses OUT instructions, called vertical output (bottom OUT with OUT Y004 M101) The vertical output, if the order is … Continue reading Mitsubishi PLC Programming FX2N PLC AND, ANI instruction

0 LD X000 1 OUT Y000 2 LDI X001 3 OUT M100 4 OUT T0 K19 7 LD T0 8 OUT Y001