00002 is the timer input,10000 is the timer output coil.00002 closed, TIM000 timing ，Arrived at the designated time, 10000 is ON;00002 off, TIM001 timing， Arrived at the designated time, so that 10000 is OFF.

In the elevator shaft on each floor is equipped with a magnetic sensors, respectively 1YG, 2YG, 3YG, 4YG, 5YG, while the car is equipped with a side length of the magnet separator plate, if the elevator up from the first floor, then magnet separator plate and then click insert sensor. When the magnet separator plate … Continue reading PLC floor control loop

SET: set command, keeping the action ON the directive.RST: reset instructions, keeps the action OFF directive.SET command can be used to Y,M,S,T,C Y,M and S,RST directives can be used to reset or D,V and z-zero Word elements.If X0 figure 1 normally open contact connected, Y0 to ON and keep the State, even if the X0 … Continue reading Mitsubishi PLC SET, RST instruction

PLS (Pulse): rising differential output directive.PLF: falling edge of differential output directive.PLS and PLF command can only be used for the output relays and auxiliary relays (does not include special auxiliary relays). M0 in the figure only in the X0 normally open from open to close (X0 rising edge) when a scan cycle for ON,M1 … Continue reading Mitsubishi PLC PLS, PLF instruction

FX series PLC basic logical instruction 20 or 27, step instructions 2, command more than 100 pieces (different series). FX2N this section, for example, described its basic logic instructions and step ladder instruction and its application.FX2N total 27 basic logical instructions, containing some 20 basic logic series PLC instructions.Master instruction (MC/MCR)(1) MC (master instruction) for … Continue reading Mitsubishi FX series PLC master command (MC / MCR)

FX series PLC basic logical instruction 20 or 27, step instructions 2, command more than 100 pieces (different series). FX2N this section, for example, described its basic logic instructions and step ladder instruction and its application.FX2N total 27 basic logical instructions, containing some 20 basic logic series PLC instructions.Stack directive (MPS/MRD/MPP)Stack instructions are the new … Continue reading Mitsubishi PLC MPS, MRD, MPP instructions

0 LDP X000 1 ORP X001 2 OUT M0 3 LD M8000 4 ANDP X002 5 OUT M10 LDF X000 1 ORF X001 2 OUT M0 3 LD M8000 4 ANDF X002 5 OUT M1

Instructions:When the branch circuit (parallel circuit) circuit when connected in series with the front, use the ANB instruction, starting point for branch with LD,LDI command, ANB for parallel circuit blocks after the end of the instruction, and in front of the circuit in series.  0 LD X000 1 OR X001 2 LD X002 3 AND X003 … Continue reading Mitsubishi PLC ANB instruction

Instruction descriptionMore than 2 contacts connected in series circuit series circuit. Series circuits connected in parallel connection, the branch started with LD, LDI instruction and branch ends with ORB instruction. ORB told ANB behind the directive and directive, is without a soft element address number of independent instructions. When there are multiple parallel circuits, if using ORB … Continue reading Mitsubishi PLC PLC’s ORB instruction

Instructions:OR parallel connection, ORI/1 contact instructions.More than 2 contacts connected in series and this series circuit with other circuits connected in parallel, using ORB directives referred to later.OR,ORI is the directive from the start, and the previous step LD,LDI instructions, connected in parallel. No restrictions on the number of parallel connections, but when using the … Continue reading Mitsubishi PLC PLC’s OR, ORI instructions